7
Page 7 of 8
7
CROSS BAR FITS HERE
NOTE: IT IS VERY IMPORTANT
THAT THIS CROSS-BAR IS FITTED TO
MAINTAIN THE STRENGTH OF THE FRAME
LABEL
7
HEADBOARD END
D
F
C
G
B
C
I
7
I
x1
B
x2
C
x4
D
x1
x2
G
x2
F
Fitting Cross Bar - Use Pack 'B'
Stage
8
Stage
10mm
Carefully hold cross bar (7) in position under the first set of holes in
the support bars.
The holes to use for cross bar are clearly labeled - look carefully at the
drawing. Note that the cross bar must be fitted in this position
otherwise the gas lift cylinders will be damaged.
Using last two bolt sets (F), (C), (B) & (G) loosely clamp cross bar
to underside of the slat frame support bars.
Carefully lay frame down. Make sure there is an even
gap each side of about 10mm, as in the sketch.
Hold frame then tighten all six bolt sets 100% using spanner (I) & Allen key (D).
Fitting Slat Frame - Use Pack 'B'
I
x1
D
x1
