© DreamLine
All Rights Reserved
© DreamLine
All Rights Reserved
11
MYSTERIE shower door manual Ver 6 Rev 7 07/2018
©2018 DreamLine. All Rights Reserved
**NOTE:
Step #11 has an option for installing the guide rail
brackets to the wall using anchors. However,
the manufacturer
strongly recommends installing these heavy doors to the
studs or to pre-installed 2”x 6“ wood reinforcements behind
the wall in the area where the guide rail brackets will be
attached to the wall.
1
2
Ø5/16
”
(8mm)
1
2
4**
3**
Ø3/8
”
(10mm)
see Note
3
Fig 11
Fig 12
Ø3/8
”
(10mm)
see Note
5**
6**
Separate the
Guide Rail Bracket (#08)
sleeve from the base by loosening the set
screws (leave the sleeves on both ends of
the upper guide rail)
base
sleeve
!
**For the recommended installation into a
stud, drill a Ø1/4” hole up to the stud and do
not use wall anchors. Drill an Ø1/8” pilot hole
into the stud and let the screw bore into the
wood.
7.
Drill a hole for the
Wall Bracket (#19)
using a
Ø5/16” (8mm)
drill bit and insert the
Wall Anchor (#9b)
(see Fig. 12.1 and 12.2).
Drill the holes for the
Guide Rail Brackets (#08)
using a
Ø3/8” (10mm)
drill bit and insert the
Wall Anchors (#9a)
.
(see Fig. 12.3**~ 12.6**).
**If installing into a stud (recommended), drill a Ø1/4” hole
and do not use the wall anchors (see note above). (Fig 12)
6.
After marking the positions of all the hardware, set the
Stationary Glass (#02)
with the
Upper Guide Rail (#03)
aside.
Remove the
Guide Rail Brackets (#08)
from the
Upper Guide
Rail (#03)
and the
Wall Bracket (#19)
from the
Stationary
Glass (#02)
. Place the
Wall Bracket (#19)
and
Guide Rail
Brackets (#08)
back to the outlined positions and mark the
holes for drilling.
