© DreamLine
®
All Rights Reserved
© DreamLine
®
All Rights Reserved
Tools Needed
Parts Needed
Tools Needed
Parts Needed
26
LINEA Shower Panel Installation Manual Ver 2 082021
©2021 Dr
eamLine® A
ll R
igh
ts R
eser
ved
.
Glass Width (W) + 1/2” (12.7mm) = (L)**
(see EXCEPTION below)
Cut the Return Panel Bottom U-Channel to:
Cut the Return Panel Vertical U-Channel to:
Glass Height (H) (-) 13/16” (20.6mm) = (V);
(for 72” model height, V= 71” (1803.6mm)
45°
(L)
(V)
29
09
x1
x1
TIP
Use a metal file to
deburr the cut
ends.
Cut the Vertical U-Channel to
71” for the standard 72”
model height.
NOTE
Fig 20a
Fig 20b
Fig 20c
Glass Width (+) 1/2”
45° miter
1/2”
NOTE
All 45° cuts are
referenced from the
outside dimension.
miter cut for right-hand return panel installation shown
or
or
or
29
x1
or
Glass Width (W) + 1/16” (1.6mm) = (L)
Cut the Inline Panel Bottom U-Channel to:
45°
TIP
Use a metal file to
deburr the cut end
Fig 21
(L)
Glass Width (+) 1/16”
45° miter
NOTE
All 45° cuts are
referenced from the
outside dimension.
miter cut for right-hand return panel installation shown
or
Plumb line
Out-of-plumb
at the bottom
If Less than 90°->
A
Plumb line
**EXCEPTION:
If the wall is out-of-plumb
at the bottom, dry-fit the Vertical
(#09) and Bottom (#29)
U-Channels onto the Panel Glass
and place into the finished
opening. Mark the Bottom
U-Channel where the glass edge is
and proceed to trim. The maximum
out-of-plumb adjustment is 1/2”
(12.7mm).
!
wall is
out-of
-plumb
20
21
