14
ENIGMA-X / SPARKLE manual Ver 6 Rev 4 07/2016
protective
padding
M5 X 10
Part#22
- Small stationary Glass Bottom Bracket
ST4.2 X 40
face plate
Fig 14b
**
use anchor
with tile threshold
use a pencil or a
center-punch to
mark the hole
1
2
3
4
*see note
5
protective
padding
NOTE:
Before you install the
Stationary glass (#02)
, you
need to take the
Door Glass (#05)
into the shower area
and lean it against the wall. After the
Stationary glass
(#02)
is installed, it may not be possible to easily get the
door glass into the shower.
Always use padding to protect the glass and shower
surfaces.
NOTE:
DO NOT attach the handle to the door glass until
instructed to do so.
Do Not attempt to lift the door glass with the handle as
this may result in damage to the glass and/or serious
personal injury. Use a professional grade glass suction cup
and an assistant.
13b.
If installing the 72” model,
repeat step#13a for the
Small Stationary Glass bottom bracket (#22).
Loosen the
set screw and remove the
guide block face plate
(Fig. 14b.5)
Apply silicone to the underside of the
Guide Block (#22)
and
screw the
Guide Block (#22)
to the threshold.
*NOTE:
◾
For installation into an acrylic threshold:
drill an
Ø1/8”(3mm)
hole and use the
ST4.2 x 25mm
countersunk screw (#17)
OR
◾
For installation into a tile threshold:
drill a
Ø5/16”(8mm)
hole and use the
ST4.2 x 40mm
countersunk screw (#26) (with anchor (#09b) for tile)
For tub installations: the bottom bracket must be screwed
down to the tub deck.
See Fig 14b for details
