6
EN
CLEANING AND MAINTENANCE
Your throw is suitable for washing. Check the washing instructions on the label of your throw to wash
it correctly.
WARNING! Always disconnect the appliance from the mains
supply before cleaning or performing maintenance.
BEFORE WASHING OR STORING YOUR THROW:
1. Disconnect the control from the mains socket.
2. Disconnect the connector (2) (Diagram [A]) from the throw by pressing the push buttons at the sides of
the control connector (1).
3. Ensure that the controls are not connected and none of the wires have worn through the fabric.
4. It is important to measure the throw before washing and check that the dimensions are approximately
the same before drying.
MACHINE WASHING
• The throw can be machine washed at 40°C on a wool programme.
• Only the gentle spin cycle is to be used. DO NOT use an extra spin cycle.
TUMBLE DRYING
• Tumble dry at a low temperature.
• DO NOT use the throw until it is completely dry.
HANGING THE THROW OUTSIDE TO DRY
• The throw must be stretched back to approximately its original size during the drying process. This
is best done whilst damp, working from side to side, stretching a piece at a time. This procedure may
need to be repeated a few times until fully dry.
• Make sure the wires are not kinked or twisted. It is easier to check the wires by placing the throw
against the light.
• If problems arise with the wires after having dryed the throw or if it does not return to its original size,
return it to our authorised Service Centre for a safety check.
WARNING! Examine the appliance against the light to make
sure the cables are not bent or twisted.
WARNING! If the appliance does not resume its original size or
if problems arise with the internal cables contact an authorised
service centre for a safety check.
WARNING! Hang the appliance without applying pegs so as
not to damage it.
STORING THE THROW
When not in use, store as follows:
When storing your throw, allow it to cool down before folding.
• Make sure your throw is dry if it has been washed.
• Fold your throw loosely being careful not bend the wires too forcefully.
MI002690_F20.indd 6
30/03/17 16:05
