4
EN
SYMBOLS
Protection class II
Prohibited actions
Carefully read the operating
instructions
Important note
Warning
Children under 3 years old not
allowed
Do not use folded or creased
Do not insert pins or needles
Wash at maximum 40° C on a
wool programme
Do not bleach
Tumble dry, low heat
Do not dry clean
Do not iron
DESCRIPTION OF THE APPLIANCE
Refer to the illustrative drawing at the beginning of this instructions booklet to verify your appliance
equipment.
1. Blanket connector
2. Control connector
3. Led display
4. 1-5 All night use temperature settings
5. Fast pre-heat setting Ready for Bed in 5 minutes
6. Timer display 1 hour or 9 hours
7. Timer/standby button
8. Ready for bed fast pre-heat button
9. Temperature button
10. Standby display
11. On/off switch
POSITIONING AND FITTING INSTRUCTIONS
ATTENTION! Your overblanket must ONLY be used as an
overblanket, i.e. over the occupant of the bed or chair/sofa.
POSITIONING THE OVERBLANKET (Diagram [B] and [C] on page I)
1. Make up the bed as normal using a top and bottom sheet.
2. Spread the overblanket over the top sheet ensuring it is lying flat without any rucks or creases.
3. The connector must be at the foot of the bed.
4. Do not fold or tuck in any of the wired areas, connector or the lead to the control as these actions could
result in activating the over heat protection system.
5. Additional bedcovers can be placed on top of the electric overblanket in order to avoid loss of heat.
6. You can also place the overblanket inside the duvet cover, then place the duvet on top to keep the heat
in. Ensure that the connector is at the bottom end of the duvet cover.
7. If using the overblanket on a chair or sofa, place it over you to keep you warm and cosy.
8. You may wish to wrap the blanket around you, but do not wrap tightly or sit on the blanket as this may
cause the overheat protection system to activate.
9. The connector must be at foot of the blanket.
MI002689_D33.indd 4
30/03/17 16:06
