Operation & Controls
1. Switch controller to ON position.
2. Set temperature “Body” or “Foot” from 1–4 heat setting. Each
can be used separately.
3. Set “Time” button to choose the heating time you need for your
body and feet ranging in 1 – 9 hours.
NOTE: This will help to dry out any moisture which has been
accumulated in the mattress. You may notice some odour when
using the blanket for the first time due to the insulation material.
This is harmless and will disappear soon. The highest mode (4 heat
setting) must be used only for preheat and not for continuous
operation. The 4
th
heating level will automatically transfer to the 3
rd
level after 3 hours working. The other modes can be used
continuously. It is recommended to preset heat setting at number 2
if blanket is to be left on all night.
Remarks: If all the LED lights flashes simultaneously, please check if the
connector is properly connected, then re-operate the controller. If the LED
lights flash again, the unit is damaged.
Care and maintenance
Before cleaning
Disconnect the blanket from the mains supply, and then disconnect
the controller from the blanket. Store the controller away carefully.
Cleaning
Do not dry clean this blanket
The blanket has waterproof heating elements making it safe to
immerse in water and wash by hand or machine. Always remove
the controller first – do not allow any part of the controller to be
immersed in any liquid.
Machine Wash
With the controllers detached the blanket can be washed in a
machine (size permitting).
Wash on WOOL or DELICATES cycle with a neutral detergent or
mild soap powder at a wash temperature of 40
o
C. Do not use high
speed or extra spin cycles.
