PiaRef
-
User's Manual
Rev 31/03/16
19
© 2014-2016 Dream S.A.S.
11. Production Test
11.1 Overview
Production test is implemented in Dream reference firmware. It allows easy testing of each manufactured boards at
the final step of production.
11.2 Starting Production Test
While starting-up the 5704PIA-DK board, press highest F# and C for 2 seconds. Display and LEDs go to Off state.
11.3 LEDs and switches test
Switches with one LED (excepted instrument select switches): Press each switch to test it and its LEDs. LED is On
when switch is pressed and Off when switch is released.
Switches with more than one LED: Press few times the same switch until you have seen each LED On and Off.
Switches without LED: Press the switch 8 times and check each time if one segment is On in the display.
- MENU switch is for high digit test
- PLUS switch is for medium digit test
- MINUS switch is for low digit test
Instrument select switches: Press switch to test its LED. LED stays On until another instrument switch is pressed.
Firmware version: Pressing the Slider Assign switch displays the firmware version number on 3-digit display.
11.4 Sliders test
Slider 1: Press Instrument 1 switch. Instrument 1 LED is On. Move slider 1 from left to right. Display shows values
increasing regularly from 0 to 127
Slider 2: Press Instrument 2 switch. Instrument 2 LED is On. Move slider 2 from left to right. Display shows values
increasing regularly from 0 to 127
