PARTS
III. Mounting Process:
1.
Put the tray in the designated position and level it using water level. (Step1)
NOTE:
If the tray is not correctly leveled doors may not operate as required.
2.
Apply caulking silicone to boarders of the tray and then to the edges to protect the unit from leaking.
Make sure all the seals are filled up. Push the tray all the way down into the corner and remove the
excess caulking using a soft cloth. Allow the caulk to dry before proceeding the shower enclosure
assembly. (Step2)
3.
Put apart the middle column assembly with the showerhead. (Step3, Step4)
4.
Fasten the back part of the middle column assembly to the wall using 4 self-tapping screws #3 and
dowels #7. (Step6)
5.
Tighten up the water pipe connector using the part #8 (Step7), plug the water hose into the water pipe
connector and tighten it up using part #9. (Step8)
6.
Plug the hot and cold water hoses to the water supply. (Step9)
7.
Place the front part of the middle column back and fasten the assembly with the 4 original bolts #5.
(Step10)
8.
Locate the wall connecting profiles, level them and mark the holes on the wall according to the holes on
the wall profiles. (Step11)
9.
After drilling, insert plastic dowels (part #7) and apply caulking silicone to the back part of the profile
and then fasten the wall connecting profiles to the wall using (quantity) screws. (Step12)
10.
To connect the water pipes from the side jet columns repeat Steps 7 and 8. Place the front cover parts
(Step13) and screw them tight. Keep in mind that you should not push the front parts of the columns by
the jets to prevent them from damaging. Make sure the jet columns are leveled (Step14).
11.
Attach waterproof plastic strips to the side glass panels (Step15) and insert them into the side jetted
columns (Step16).
12.
When the side glass panels are in the place (Step17), insert the metal brackets into the support bar in a
following order: see Step18.
13.
Then insert the support bar into the slots of the side jet columns and fasten it (Step20).
14.
Secure the side glass panel to the metal bracket using the parts #1, 2, 4, 10 and 11. (Step21)
15.
Secure the bottom glass door pivot brackets to the entry door using the same parts #1, 2, 4, 10 and 11.
The bottom of the entry door is determined by the position of the holes for the brackets (Step22). Insert
the bottom pivots into the slots, then insert the top pivots into the slots and then secure the bracket to the
entry door making sure you place the plastic gaskets in between the glass and metal nuts (Step23).
16.
Secure the brackets to the support bar to prevent them from sliding back and forth using part #6
(Step24).
17.
Attach handles, making sure there are plastic gaskets in between the glass (Step 25).
18.
Attach the bottom waterproof plastic strip to the bottom of the doors (Step 26).
