These are the SHIFT controls, that you can access while holding down the
ON button. Remember, in order to store this so that the pedal remembers
them the next time you power it, you must press and hold both footswitch-
es for 3 seconds!
TIME = EFFECT GAIN
Controls the level of the signal going into the effect’s line. By default, this
should be set at 50%, but in many cases, for example if you plug a hot
signal instrument, you might need to set this lower, so that the effects do
not peak.
FEEDBACK = POST FEEDBACK
This will control the amount of feedback that is send after the effect’s
section. For example, feedbacks after the Pitch Shifter will introduce the
shimmer effect. Be carefully though, as this feedback control and the main
one will add up and self-oscillation can be produced.
NOTE: On the reverb’s algorithm, this control is deactivated.
MIX = LOW PASS FILTER
This controls the Cut Off of a 1-pole Low Pass Filter.
CONTROL = TAP DIVISIONS
This is actually a multiplication over the tap tempo. It has fixed areas over
4 selections and it’s x1, x2, x3, x4.
MODE toggle switch
Tails ON/OFF ( ON = 1, OFF = 2). By setting this to ON, will allow the repeats
of the delay to be kept on even when the effect is set to by pass.
A. Send an Audio signal or an instrument to the input (mono signals it’s better to be send to the R INPUT)
B. Connect the Output to an Amp or a Monitor (mono signals should to be pulled out of the L OUTPUT)
C. Power the effect by using a 9VDC center pin negative power adapter (specialized for effect pedals)
D. Press the ON footswitch to enable the effect
E. Press both footswitches to change algorithms
F. To engage the secondary functions (SHIFT page) press and hold down the ON footswitch. While this is on hold, you have access to different parameters
G. In order to save the current algorithm’s settings, press and hold both footswitches for 3 seconds
MODE
TAILS
OFF
ON
SHIFT
HOLD
DOWN
II
III
IV
I
