Rebar Locator DR 30000 PK
DRC s.r.l. – [email protected]
Page 17
Fig. 3. 4 The Instrument Calibration
The parameters setting of each option as follows:
(1)
Rear Diameter
A range of rebar specifications: 6, 8, 10, 12, 14, 16, 18, 20, 22, 25, 28,
32, 36, 40, 50.
(2)
Component Name
Component name consists of two letters and three digits, which are
A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z, 1, 2,
3, 4, 5, 6, 7, 8, 9, 0 respectively, its default setting is HD001.
The default setting is HD001, which automatically plus one after the
confirming, and the users manually adjust as needed.
(3)
Stirrup Spacing
The stirrup spacing parameter setting: if the on-site stirrup spacing is
less than 125mm, the parameter is set to
＜
125, compensated
automatically. If the on-site spacing is greater than 125mm, the
