Installation Guide
LP20RF & DRF
Positioning the DiRF room thermostat
The Digistat is a radio frequency device which is very
flexible for positioning as there is no need for hard wiring
to the appliance. The device should be mounted in an
open area, no closer than 30cm from metal objects,
including wall boxes.
Mount the DRF on a wall which is not subject to
direct sunlight or draughts, preferably on an inside wall,
1.5 metres above the floor. The DRF must also not
be directly influenced by radiators or other appliances
giving off heat.
Mounting the DiRF room thermostat
1.
Loosen the single screw from the bottom of the
transmitter using a small flat bladed screwdriver.
2.
Carefully insert the screwdriver into the slot
located at the back of the digistat near the top and
very gently lever upwards a fraction to release
the tab securing the front of the transmitter to the
back cover. The back cover can now be secured to
the wall.
3.
Replace the front by locating in position and
pushing fully onto the back cover until the tab
engages at the top of the transmitter.
4.
Retighten the screw at the bottom of the unit to
fully secure the front to the back cover.
To cancel signal strength mode:
1.
Remove the batteries from the DRF
transmitter to cancel the constant transmission.
2.
After a few seconds the receiver display will show
‘---’ .
3.
Press ‘OK’ on the LP20RF receiver and the display
will return to the time with the ‘CH and Antenna’
flashing.
4.
Re-insert the batteries into the transmitter and the
RF link will be re-established.
6
Installation & User Guide
0
6
51
50
8
50
0
1 I
SS
B