Draytek VigorSwitch P1280, User Manual, Page: 53 / 120

VigorSwitch P1280 User’s Guide 47
range: 1~200,000,000.
Short - Specifies that the default port path costs are within
the range: 1~65,535.
Apply Save the settings or changes to the switch.
I
I
I
I
-
-
9
9
-
-
2
2
P
P
o
o
r
r
t
t
S
S
e
e
t
t
t
t
i
i
n
n
g
g
This page allows the user to configure and display STP port settings.
Available settings are explained as follows:
Item Description
Ports Use the drop down to specify the interface ID or the list of
interface IDs.
Path Cost (0=Auto) Path cost is the cost of transmitting a frame on to a LAN
through that port. It is recommended to assign this value
according to the speed of the bridge. The slower the media,
the higher the cost. Entering 0 means the switch will
automatically assign a value.
Edge Port In the edge mode, the interface would be put into the
Forwarding state immediately upon link up. If the edge mode
is enabled for the interface and there are BPDUs received on
the interface, the loop might be occurred in the short time
before the STP state change.
Yes – Enable the function.
No – Disable the function.
P2P MAC Yes – It means the STP of link type on this port is full-duplex
and directly connect to another switch or host.
No - It means the STP of link type on this port is “not”
full-duplex and “does not” directly connect to another switch
or host.
Migrate Yes – Check it to force the specified port to send one RSTP
BPDU (Rapid Spanning Tree Protocol Bridge Protocol Data
Unit).