Draper VC300, Instructions Manual

Page: 8 / 12

-8 -
MAINTENANCE
REPLACING THE DRIVE BELT
IMPORTANT
Disconnect the vacuum from the power supply
before replacing any parts.
1. Remove screw
✯✌
to release front cover
✰✌
.
FIG.3.
2 Remove the two screws
✱✌
holding the brush
housing
✳✌
in place and remove. FIG.4.
3.Holding the brush
✴✌
in the centre, pull
the belt off the driveshaft and remove the brush
with the bearings
✵✌
assembled. FIG.5. .
4. Clean the brush if required. Slide a new belt
✶✌
onto the brush
✴✌
and move it to a central
position. FIG.6
5. Replace the brush
✴✌
complete with bearings
✵✌
.
6. Place the belt over the driveshaft
✷✌
FIG.6 . (The
belt should be twisted in a clockwise direction
over the driveshaft
✷✌
as shown in FIG.7.)
7. Reassemble the brush housing
✳✌
with screws
✱✌
.
8. Replace the front cover
✰✌
and secure in place
with screw
✯✌
.
✰✌
✭✌
Fig.5
✮✌
✬✌
✯✌
Fig.3
Fig.4
✶✌
✷✌
Fig.5
Fig.6
Fig.7
✱✌
✱✌
✳✌
✴✌
✵✌
✵✌
✷✌