HEM
BAR
END
CAP
ENDC
AP
FLAN
GE
ENDC
AP
FLAN
GE
PLEASE NOTE:
Use an appropriately
sized crimping tool, such as the one
shown below
(supplied by installer)
.
Section 4 -
Installing Cable Guides
10.
Reassemble cable
and nut on the
bottom bracket and
tighten
(wall mount
option shown)
.
1.
Loosly fasten the
nut on the cable
on the bottom
bracket
(wall
mount option
shown)
.
3.
Pull cable through the
hole in the endcap
flange until taut.
4.
Mark cable at
the bottom of
the endcap
flange.
5.
Undo the nut and
pull the cable down,
until the mark aligns
with the bottom
of the endcap
(deck mount
option shown)
.
7.
Crimp the barrels
approximately
1/8
"
(3mm)
above
pencil mark.
7
(20cm)
8.
Cut cable
approximately
1"
(25mm)
above
crimped barrels.
9.
Pull cable
down, until
crimped
barrels are
resting on
the flange.
CAUTION:
Headbox
shown removed from
image for demonstration
purposes ONLY.
Do not remove endcap or
disassemble unit.
ENDC
AP
FLAN
GE
6.
Strip cable
to that spot.
2.
Pull cable up through
hem bar eyelet.
page 4 of 8
N E
