Section 2 -
Mounting Case with Brackets - Wall Installation
Section 3 -
Mounting Case Directly to Ceiling or Wall
1.
Attach Mounting Brackets to Case as a spacer between Case and wall.
Please Note:
Leave a 1¾"
(44mm)
gap between Endcap and Mounting Bracket
(Fig. 4)
, and tighten set screws.
2.
Remove roller assembly.
A.
Remove screws from bottom of Case, remove Cover and set aside
(Fig. 5)
.
B.
Remove Quick Release Pin from Idler End of Roller Assembly.
C.
Remove Roller Assembly, Idler End first, and set aside.
3.
Mount to Ceiling / Wall.
A.
Using mounting holes in endcaps as a guide
(Fig. 6)
, drill pilot holes on
both ends of Case.
B.
Attach to mounting surface using appropriate fasteners.
Please Note:
Installer is responsible for selecting mounting hardware
appropriate for site conditions.
4.
Once Case is secured to mounting surface, re-install Roller Assembly,
Quick Release Pin and Cover.
5.
Proceed to Section 4
(Installing Cable Guides)
.
Section 2.1 - Attaching Mounting Brackets
1.
Attach mounting brackets to wall using #10 flat head screws installed flush with bracket.
Be sure to use AT LEAST 2 of top mounting holes
(Fig. 2)
.
Section 2.2 - Attaching Case to Mounting Brackets
1.
Attach Case to brackets and tighten Set Screws
(Fig. 3)
.
2.
Proceed to Section 4
(Installing Cable Guides)
.
Figure 2
Figure 3
Figure 4
Figure 5
Tighten
set screws.
1
2
3
Leave a 1
"
(44mm)
gap.
Attach
mounting bracket
as spacer and
tighten set screws.
Remove
cover.
Remove quick
release pin.
Remove roller
assembly.
A
B
C
Remove screws from
bottom of case.
WALL
MOUNT HOLES
CEILING
MOUNT HOLES
WALL
MOUNT HOLES
CEILING
MOUNT HOLES
Figure 6
page 3 of 8
N C
