A
B
C
B
A
A
B
C
Attach idler end
to Idler Bracket.
Rotate Hook
to secure.
Attach Retaining
Clip to Shaft.
IDLER
PANEL
IDLER
PANEL
IDLER
PANEL
9.
Lock shaft in place.
(Endcap option shown.)
SHAFT
FULLY
EXTENDED
ROTA
TE
to
E
XT
EN
D
SHAFT
HALF
EXTENDED
SHAFT
FULLY
RETRACTED
ROTA
TE
to
R
ET
RA
CT
6.
Replace motor end roller to
endcap or bracket.
(Bracket option shown.)
Caution:
Ensure the operator-end
fabric/roller assembly's coupler
shaft is
fully retracted
(see "Operating the Retractable Shaft.")
.
7.
Repeat steps 3-6 to install the next
coupler
(s)
to mounting surface.
Final
(Idler-end)
Fabric/Roller Assembly
(Bracket option shown.)
CAUTION:
The end of the previously-
installed coupler shaft should be flush
with the outside edge of the bearing.
If coupler shaft extends beyond
the bearing,
retract coupler shaft of
the previously installed roller to the
intermediate position.
8.
Lift both ends of the idler-end fabric/roller
assembly into place and align between
the brackets/endcaps.
A
Installer #1 places the idler-end
sliding shaft onto the
idler-end bracket
or endcap.
Installer #2 fully extends coupler shaft of
previously installed roller by rotating the
metal ring clockwise about ½ of a turn when
viewing the face of the coupler assembly
(see "Operating the Retractable Shaft" and Fig. 2)
,
until the shaft extends fully into the receiver
of the idler-end fabric/roller assembly.
CAUTION: Ensure shaft is LOCKED IN PLACE
with retaining clip!
page 7 of 12
Motorized FlexShade
®
(Coupled)
