Assembly of the mower
1. Locate from the loose parts the two lower
handle parts and the two handle screws.
Insert the short end of each handle into the
sockets at the rear of the mower deck so the
concave side of the handle is innermost.
Once the handles are positioned locate the
holes in the side of the deck that are in line
with the socket and make sure the
corresponding hole in the handle lines up.
Screw in the self tapping handle screws but do
not over tighten as this will damage the
plastic.(Fig.1).
2. Locate from the loose parts the two bolts, caps,
knobs and top handle. Make sure the cable
restraint is positioned over the handle below
the switch before the handles are assembled.
Push one of the bolts through the top handle
on the right hand side (same side as the
switch) from the inside so the square under the
bolt head engages with the square in the
handle. Put the second bolt into the left hand
side of the handle from the inside so the bolt
only just protrudes through the handle (Fig.2)
.
Make sure the motor lead is inside the handles
and feed the first bolt through the right lower
handle and then push the other bolt through
the other lower left handle. Fit both caps onto
the bolts so the hollow side faces outwards
and then secure with the two knobs.
3. Use the cable clips supplied to clip the motor
lead to the handles with the cable restraint
above the uppermost clip (Fig3).
Assembly of the grass box
1. Offer the two halves of the grass box together.
Clip the two halves together ensuring that all
the tongues locate into their corresponding
grooves and all the clips are secure (Fig.4).
2. Carefully fold the two flaps under the top
handle together making sure the fingers knit
together. Do the same for the flaps under the
lower handle.
- 8 -
ASSEMBLY INSTRUCTIONS
Fig.1.
Fig.2.
Fig.3.
Fig.4.
