Push
Fabric
Asse
mbly
Push
Fabri
c Ass
embly
UNLOCK
ROTAT
E
ROTAT
E
FA
BR
IC
P
AN
EL
S
AL
IG
NE
D
LOCK
SPANNER WRENCH DETAIL
Please note:
If needed, the fabric panel heights can be adjusted so that the bottom edges of the fabric panels are aligned. On large units, this procedure should be
done on only one panel at a time to minimize the amount of fabric weight that must be supported during the adjustment procedure.
Section 4 -
Fabric/Roller Assembly Alignment
6.
Operate the unit to check fabric
position, tracking, etc.
7.
Install
next panel.
2.
Push the fabric/roller assembly approximately
3/16
"
(5mm)
toward the operator-end of the unit. The
fabric/roller assembly will move
approximately
3/16
"
(5mm)
toward
the operator end.
3.
Rotate the fabric/roller assembly
in either direction to raise or lower
the fabric panel.
4.
Allow the fabric/roller
assembly to move back
and away from the
operator end of the unit,
and check position of
fabric panels.
5.
Tighten the locking ring by firmly rotating it
approximately ¼ turn clockwise
(reverse of step 1)
.
Caution:
Locking ring on the idler-end coupler assembly
MUST BE fully tightened following height adjustment. Wear a
heavy glove to grip the locking ring. Tighten the locking ring
until it is fully locked and will not rotate any further. Ensure
that it will not loosen. If it cannot be tightened by hand, use a
flat screwdriver or other tool to assist.
Motor Shade Panel
Begin with
Motor Shade Panel.
Begin with
Motor Shade Panel.
1.
Continue with
Intermediate
Shade Panel.
Continue with
Intermediate
Shade Panel.
2.
Continue with
Intermediate
Shade Panel.
Continue with
Intermediate
Shade Panel.
3.
Finish with
Idler Shade Panel.
Finish with
Idler Shade Panel.
4.
1.
Unlock height adjuster mechanism
(or coupler shaft receiver)
located
at the operator-end of fabric roller assembly that is being adjusted
by rotating the metal ring approximately ¼ turn counterclockwise
(when viewing the face of the coupler assembly)
.
Please note:
Do not use this procedure to adjust the operator-end assembly.
Use the limits to set the down travel of the operator-end assembly.
HEIGHT
ADJUSTMENT
MECHANISM
COUPLER MOUNTED TO STRUCTURE
SPANNER
WRENCH
UNLOCK
LOCK
page 6 of 12
Motorized FlexStyle
TM
(Coupled)
