Section 1 -
Preparation for Installation
Caution:
Before mounting shades, verify measurements on label provided with shade, and ensure unit is installed at correct width.
Please Note:
Installer is responsible for selecting mounting hardware appropriate for site conditions.
1.
Ensure mounting surface is strong enough to hold the Exterior Motorized FlexShade
®
XL.
2.
Verify unit measurements and make sure it will fit in the desired location.
Section 2 -
Mounting Headbox with Cassette Brackets
Section 2.1 - Wall Installation
Section 2.2 - Ceiling Installation
Caution:
Mounting brackets
required for proper spacing of unit
off the wall for side channel
alignment.
1.
Attach mounting brackets to the wall using #10 flat
head screws installed flush with bracket.
Please Note:
Be sure to use AT LEAST 2 of the top
mounting holes
(Fig. 3-A)
.
1.
Attach mounting brackets to ceiling using #10 flat
head screws installed flush with bracket. USE ALL
FOUR
(4)
mounting holes
(Fig. 3-B)
.
2.
Attach Headbox to brackets and tighten Set Screws
(Fig. 3-B)
.
3.
Install Cable Guides
(Section 3)
.
Please Note:
Hem Bar does
not
retract into
the Headbox and must be accounted for if
mounting over a swinging window or door.
3.
Mounting brackets MUST be installed with a
gap of 1
3/4
"
(44mm)
between the Endcap and
the Mounting Bracket edge
(Fig. 1)
. Mark wall,
jamb, or ceiling.
4.
Drill small starter holes
(if necessary)
in
mounting surface.
5.
Determine which headbox style is being
used
(Fig. 2)
.
2.
Attach Headbox to brackets and tighten
Set Screws
(Fig. 3-A)
.
3.
Install Cable Guides
(Section 3)
.
ENDC
AP
MOUNTING
BRACKET
1
"
(44 mm)
Figure 1
5"
(127mm)
5"
(127mm)
5"
(127mm)
5"
(127mm)
Curved
Headbox
Angled
Headbox
Figure 2
HEADBOX STYLES
OVE
RHE
AD
STR
UCT
URE
1
2
4
3
Tighten Set Screws
Figure 3-B
Figure 3-A
1
2
4
3
Tighten Set Screws
page 3 of 10
Exterior Motorized FlexShade
®
XL
