9.5 BELT CLIP - FIG. 8
The spring steel belt clip is convenient for hanging the
drill temporarily. The clip can be installed on either side
of the tool.
To install the clip
, locate the clip in position and
fasten with screw
supplied, take care to not
overtighten and strip the thread.
FIG.8
9. BASIC
OPERATION
9.6
DRILLING WOOD AND PLASTIC:
To prevent wood splitting around the drill holes on the reverse side, place a piece of scrap
timber under the material to be drilled.
9.7 DRILLING
MASONRY:
Start drilling at a low speed to prevent the drill bit from wandering. Once penetration is
achieved, fully depress the trigger to achieve maximum speed and hammer power.
9.8 DRILLING
METAL:
Metals such as sheet metal, aluminium and brass may be drilled. Mark the point to be
drilled with a centre punch to help the drill bit tip to locate.
9.9 SCREWDRIVING:
To prevent a slip or damage to the screwhead, match the screwdriver bit to the screwhead
size. To remove screws, select correct position on collar
move the direction switch to
the reversing position and apply pressure to the screwhead and depress the trigger slowly.
16
