Draper 71091, Instruction Manual, Page: 12 / 24

8. PREPARING THE WELDERS
Warning!
Do not make any adjustments, maintenance or servicing with the machine
connected to the power supply.
8.1 FITTING THE WHEELS (71095 ONLY)
i. Fit the front castor wheels using the 8 screws provided.
ii. Slide axle through both axle loops (4 per wheel).
iii. Fit one circlip to the groove on the axle closest to machine body each side.
iv. Slide on a wheel followed by the plain washer
and then another circlip, repeat for other side.
v. Fit the plastic caps.
8.2 LOCATION
Locate the machine in close proximity to the correct
power supply and allow 500mm air gap around to
ensure sufficient ventilation. There is one cooling fan
located in the rear of the machine housing which
must be kept clear. Equally, ensure no debris can be
drawn into the machine.
Make certain the location does not pose any hazards
as detailed in the safety instructions, before
attempting to start the machine.
8.3 INSTALLING THE
FILLER WIRE - FIGS. 1 - 4
The welding machines are designed to accept the
standard size drums of wire up to 15kg.
Do not let the filler wire become uncoiled or tangled
as this will lead to problems with delivery to the
welding torch.
Select the filler wire suitable for the parent metal
and with a gauge to match the welder specification.
Note:
If the welding machine is not regularly used,
remove the wire which is prone to rusting and will
cause feed problems next time.
FIG. 1
FIG. 2
12