Draper 58157, Instructions Manual

Page: 5 / 12

ASSEMBLY
1. Attach both base supports
✖✌
to the main frame
✕✌
using bolts
✗✌
, washers
✘✌
, spring washers
✙✌
and nuts
✚✌
.
2. Stand the frame in the upright position.
3. Support plate
✜✌
and ram plate
✛✌
are held in position on the frame
✕✌
by using bolts
✢✌
, washers
✘✌
, spring washers
✙✌
and nuts
✚✌
. Ensure ribs on both plates are parallel with the front and rear
cross plates of frame
✕✌
.
4. The ram
✕✗✌
is fitted through the clearance hole in the support plate
✜✌
and then screwed into
position in the ram plate
✛✌
. (Ensure screwed right in).
5. Fit the gauge
✕✜✌
in place on the ram
✕✗✌
.
6. Hang the pump (14) on hook located at the top of main frame
✕✌
.
7. Attach the hydraulic hose
✕✛✌
to the ram
✕✗✌
.
8. Push the two support pins
✕✔✌
through the holes in the main frame
✕✌
and place the table
✕✕✌
in
position.
NOTE: For parts references see parts listing and drawing.
- 5 -