Draper 12044, User Manual

Page: 10 / 16

- 10 -
8. PREPARATION & CONNECTIONS
8.2 VCI CONNECTOR
The VCI connector only applies to the passenger vehicles of 12V. It can be installed on the OBDII
vehicle's DLC directly or via the extension cable.
8.4 NETWORK SETUP
This tablet supports WLAN connection.
1. On the home screen, tap "Settings"> WLAN.
2. Slide the WLAN switch to ON, the system starts searching for available WLAN networks.
3. Select a wireless network. If the chosen network is open CRP MOT will connect automatically, if
the selected network is encrypted, a network password will need to be entered.
4. When "Connected" appears, it indicates the tablet is properly connected to the Internet.
*Note: when WLAN is not required this should be disabled to conserve battery power.
OBD II 16pin connector
(For connecting to vehicle's DLC)
Note: Remember to remove the VCI
connector from the DLC and
re-insert it into the slot on the back
of the tablet after use to avoid loss.
8.3 CHARGING & TURNING ON
1. Connect the power adaptor to the Universal Serial BUS port
(5)
of the tool.
2. If the tool is being charged:
A charging indicator displays.
Once the indicator turns, charging is complete.
3. Pressing the POWER button
(1)
will start the tool and enter the home screen.
Note: On first use of the tool, or if the tool remains idle for a long period of time, there may be
insufficient battery power to start the tool. Please charge for a minimum of 5 minutes before
attempting to turn it on again. Please use the power adaptor included within the kit to charge the
tool. No responsibility can be assumed for any damage or loss caused as a result of using any
power adaptor other than the one supplied.