12
Reset to Factory Defaults
Resetting the instrument to factory defaults will erase all user data,
communication settings, including recorded logs and events, reports and
instrument setup files.
The steps below show how to manually reset the HDPQ DataNode to
factory configuration.
NOTE
: The reset button is recessed and can be found at the rear panel
of the instrument. A paper clip, pin or similar item is needed to
press in the reset button.
Step Action
1
Unfold the paper clip to form at least a 1-inch long straight
line wire.
2
Gently insert the paper clip (or other tool) into the “Reset”
button hole at the rear panel of the HDPQ DataNode.
Press in the internal reset button and hold for ten (10)
seconds.
Continue to hold until the Status LED indicator at the front
panel stops blinking which indicates that the reset and reboot
process has been initiated. If you let go before 10 seconds,
the unit will reboot but it will not reset.
3
Once reboot is completed, the Status LED indicator will blink
in a heartbeat fashion to indicate that the unit has returned to
normal operation.
At this point, the instrument has been reset to factory
configuration, including the following default connection
settings:
Default User name:
admin
Default Password:
Dranetz
Wired Ethernet IP address will be fixed at
192.168.0.30
.
NOTE
: All saved data and setups will be lost when you reset
the instrument settings to factory defaults.
Summary of Contents for HDPQ-DN-MVSTR
Page 40: ...40...
