MMTS20
STEREO
ENCODER
POWER
PILOT
LOCK
AUDIO LEVEL
ON
TEST
TONE
OVER-
MOD
OFF
F1
F2
F3
F4
F5
2
FRONT PANEL CONTROLS and INDICATORS
Figure 1
F1 - POWER Indicator
Lights when the unit is connected to the
required source of DC power.
F2 - PILOT LOCK Indicator
Lights to indicate that a video signal is applied
to the rear panel VIDEO INPUT connector and
that the MMTS20 is locked to the video
horizontal sync.
F3 - TEST TONE Switch
Switch to the 'ON' position to enable an internal
test tone to aid system audio level setup. See
the 'Installation' section of this manual for setup
information. The normal position of this switch
is the 'OFF' position.
F4 - OVERMODULATION Indicator
Lights to indicate greater than 25 kHz of main
channel deviation. After system audio
modulation levels are properly set, and with left
and right audio source input, adjust the AUDIO
LEVEL control (see item F5) to a point where
the OVERMODULATION indicator just
remains off.
F5 - AUDIO LEVEL Control
The setting of this screwdriver adjustment
determines the audio input signal level. After
system audio modulation levels are properly
set, and with left and right audio signals within
the 250 mVrms to 2.5 V rms range, set this
control to a point where the
OVERMODULATION indicator just remains off
(see item F4).
SPECIFICATIONS 7
Specifications subject to change without notice or obligation.
AUDIO INPUT
Input Impedance:
Input Level:
VIDEO INPUT
Input Impedance:
Input Level Range:
COMPOSITE OUTPUT
Output Impedance:
Output Level:
STEREO PERFORMANCE
Stereo Separation:
Total Harmonic Distortion:
S/N Ratio:
Frequency Response:
Spurious Subcarrier:
NOTE:
TEST TONE
Frequency:
Amplitude:
GENERAL
DC Power Input:
Operating Temperature Range:
Size:
Weight:
40 K Ohms balanced,
20 K Ohms unbalanced.
250 mVrms to 2.5 V, front panel adjustment.
High impedance, intended to be paralleled with paired
A/V modulator unit.
Input Level Range: 0.5 Vp-p to 2 Vp-p.
100 Ohms, intended to drive high impedance audio
input of paired A/V modulator.
10 mV/kHz, ±10%.
1.1 Vp-p for a 100% modulation signal.
Greater than 20 dB.
Less than .25%.
Greater than 65 dB.
Within ±1 dB from 40 Hz to 12.5 kHz.
-50 dBc typical.
System performance is dependant upon paired modulator.
10.396 kHz ±50 Hz.
0.5 Vp-p ±10%; all output levels are calibrated to the
level of this tone and is used to set system audio
levels for proper stereo operation. The paired A/V
modulator audio response must be set for “Flat”
(pre-emphasis defeated).
+12 V ±5% @ 150 mA
(+5 V is not required for this unit).
0
0
C to +50
0
C ambient.
1” W x 3.5” H x 7.5” D
(2.5 cm) W x (8.9 cm) H x (19.1 cm) D.
10.7 oz. (0.3 Kg).