© 2018 Dragonfly
Fixed Projection Screen Manual
180822-0935
2
Step 1. Unpack the Screen
Lay out all parts on a clean, flat surface. To prevent damage, do not unpack the screen material at this time.
NOTE:
Quantities below may be greater than needed for assembly.
Package Contents
Thin Bezel Frame
Brackets (12)
M5x8mm Mounting
Screws (3)
Micro Fiber Cloth (1)
M5x6mm Corner
Screws (56)
Sliding Nuts
[installed]
(16)
Gloves (2 Pair)
M5x40mm Phillips
Head Screws (6)
Concrete
Anchors (6)
Center Stabilizing
Bar (1)
Screen
Material (1)
Screen Frame & Frame Bezels
(2 short, 2 long each)
Corner Brackets
(5 small, 5 Large)
Spring Tool (2)
Material Springs
[installed]
Mounting Bracket (3)
Magnets (3)
Plastic Protective
Sheet (1)
Step 2. Prepare Frame Sections for Assembly
A. Retention springs are pre-assembled. Please confirm
based on quantity noted on frame label for the short
and long frame sections.
i. The hook on the spring must be nearest the
inside frame edge.
B. Sliding nuts are pre-installed into frames, 16 total.
Sliding nuts are used to install the thin bezel caps,
center stabilizing bar, and wall brackets. Please
ensure all 16 sliding nuts are on the frames prior to
installing and tightening the corner brackets.
C. Install the corner brackets to the top and bottom
slots of the short frame sections.
i. The small bracket goes in the bottom slot, and
the large one goes in the top slot.
Step 3. Assemble the Frame
A. Slide the short frame sections into the long frame
sections.
B. Insert the 8 frame corner screws into all 4 corners
of the frame and loosely tighten to hold the frame
together.
C. Hand-tighten all four screws, ensure the corners are square, then tighten the screws completely.
D. Lift up and set aside to prepare screen material for assembly.
B
x32
C
