INSTALLATION MANUAL
Ambient Light Rejecting Fixed Projection Screens
IMPORTANT: BEFORE YOU BEGIN
• To avoid staining or scratching the screen, wear the included white gloves
during installation. Wash your hands and clean the work area before starting.
• Do not use knives or sharp objects to open the packing boxes.
• To avoid a serious fire hazard, DO NOT install the screen over an electrical outlet
or switch.
Step 5. Hang the Screen Assembly
A level, measuring tape, and drill are very helpful for this step.
A. Position the screen level on the wall and temporarily
mark the location of the top, bottom, and side edges.
For drywall installation, use a stud finder to mark the
locations of the studs behind the screen.
B. Position each upper bracket level with the top edge of
the screen, about 20" in from each side, then mark the
two mounting hole locations on the wall. For drywall
installation, center the bracket on the closest stud.
C. Beneath each upper bracket, measure 1/8” up from the
bottom edge of the screen and mark the height for the
bottom of the lower brackets.
D. Tighten the screw on each bottom bracket, then position
on the wall and mark the three mounting hole locations
for each bracket.
E. Prepare the wall for the screws/anchors:
i. Drywall studs: 5/32” drill for pilot holes
ii. Masonry: 1/4” masonry drill bit for anchors
F. Install the anchors (if applicable), then fasten the
mounting brackets using the included 5X40mm screws.
G. Loosen the retaining clamp screws on the bottom
brackets.
H. Slide the top edge of the screen over the upper brackets,
then swing the bottom of the frame over the lower
brackets and re-tighten the screws.
Care and Cleaning
Clean the screen with a soft cloth only. DO NOT use soap,
water, harsh detergents, chemicals, distilled spirits or
petroleum-based chemicals to clean the screen. Doing so
may result in severe damage to the screen or the frame
coating.
Use a household vacuum cleaner with a brush or furniture
cleaning attachment to clean the felt frame material. Avoid
using excessive amounts of water on the felt.
Dimensions
Size (A)
B
C
D
E
F*
92"
45.08''
80.2''
51.42''
86.54''
51.3’’
100"
49.02''
87.17''
55.35''
93.5''
55.24’’
110"
53.9''
95.87'' 60.24''
102.2''
60.12’’
120"
58.82'' 104.57'' 65.16''
110.9''
65’’
*-Top of upper to bottom of lower mounting bracket.
Technical Support
p.866.838.5052
E
D
B
A
F
C
20"
1/8"
20"
For drywall, center
brackets on closest studs.
