Step 7: Insert plastic supplied support rail
in between both layers of plastic. Make
sure the angle matches that of the factory
plastics and all holes align. (See Figure G)
*Plastic support rail shown to the right in raw form for contrast.
Actual piece is powder coated black
Step 8: Install supplied striker pin into 2
nd
hole down and thread into supplied U-Nut.
At this time re-install previously removed
factory hardware. (See Figure H)
Step 9: Slide Drive side seat all of the way
forward to access Torx head bolt located
on the outside corner behind seat. For
passenger side tilt seat forward to access
same bolt. Set hardware aside it will be re-
used. (See Figure I)
Step 10: Place door hinge into position so
that door hinge plate aligns with two upper
bolt holes and lower corner hole. (See
Figure J)
Dragonfire Racing
