Installation and adjustment instructions
Terrace awning Family EVO
Document name: 2010 EN Instrukcja Family EVO 2,11 | date: 08.07.2010 | page: 7 / 11
3.7.
prepare electric connection
(in case of ordering an electric engine)
CAUTION!
Electric connection may be done only by qualified personel who have proper licenses
and permision regarding local law regulations
.
Electrical connections are made in
accordance with the attached circuit diagram of connections in accordance with the
instructions of the electric drive. Awning can be connected to electricity, if
t
he power
source data matches the requirements of the engine.
When installing the motor power cable, should be noted that the cable is not twisted and that there are no
sharp edges that could lead to its damage. The switch should be located at a height of 125cm (or different if
stated by local law). The switch used must be intended by the manufacturer to control the awning. the
marginal restrictions of opening and closing the awning are pre-set by the manufacturer. After making
changes to these settings must in accordance with programming instructions included to the engine
description, carry out the process of recording these changes.
●
the Change of engine end positions
In order to make changes to the programmed marginal settings of the awning engine, follow the
instructions of the engine – instruction is attached to the product.
If scrached or damaged to the cord, do not use the awning, and call servis staff.
3.8.
Usage of crank
(for awnings with manual drive or NHK)
●
hang the crank on the eyelet of the drive. Cranking causes opening and closing the awning.
●
fabric must be wound on the appropriate side(from top), of the roller tube. Fabric rolled in the
opposite way can lead to damage to the awning fabric and construction.
WRONG
CORRECT
4.0.
Awning repair
Repairs should be carried out by a technician, who should use only spare parts from DRAGON Korgul,
Prochowski Sp.J.
CAUTION!
Arms of the awnings are under high tension of springs and the improper handling can
cause the injury.
4.1.
Replacing the drive
To carry out replacement of a failed drive, awning must be unmonted. Requires the appropriate knowledge
and skills available to the service personel. when changing the drive, be sure to secure arms. The inserted
new drive must be compatybile with the manufacturers drive and awning guidelines.
4.2.
Fabric exchange
To perform the exchange of material it is necessary to unmonte the awning. Changing the material must be
conducted by the service company or manufacturer.
