User Manual for LoRaWAN End Nodes - LHT65N LoRaWAN Temperature & Humidity Sensor Manual
6.4 How to use TTL-USB to connect a PC to input AT commands?
In PC, User needs to set serial tool(such as
, SecureCRT) baud rate to
9600
to access to access serial
console for LHT65N. The AT commands are disable by default and need to enter password (default:
123456
)
to
active it. Timeout to input AT Command is 5 min, after 5-minute, user need to input password again. User can use
AT+DISAT command to disable AT command before timeout.
Input password and ATZ to activate LHT65N,As shown below:
Page 44 / 56 - last modified by Bei Jinggeng on 2022/07/06 13:48
