Dragino LDDS04, User Manual

Page: 31 / 38

www.dragino.com
LDDS04 LoRaWAN 4-Channels Distance Sensor User Manual 31
/
38
3. Configure LDDS04 via AT Command or LoRaWAN Downlink
Use can configure LDDS04 via AT Command or LoRaWAN Downlink.
➢
AT Command Connection: See FAQ .
➢
LoRaWAN Downlink instruction for different platforms:
http://wiki.dragino.com/index.php?title=Main_Page#Use_Note_for_Server
There are two kinds of commands to configure LDDS04, they are:
➢
General Commands .
These commands are to configure:
✓
General system settings like: uplink interval.
✓
LoRaWAN protocol & radio related command.
They are same for all Dragino Device which support DLWS-005 LoRaWAN Stack. These
commands can be found on the wiki:
http://wiki.dragino.com/index.php?title=End_Device_Downlink_Command
➢
Commands special design for LDDS04
These commands only valid for LDDS04, as below:
3.1 Set Transmit Interval Time
Feature: Change LoRaWAN End Node Transmit Interval.
AT Command: AT+TDC
Command Example Function Response
AT+TDC=? Show current transmit Interval
30000
OK
the interval is 30000ms = 30s
AT+TDC=60000 Set Transmit Interval
OK
Set transmit interval to 60000ms
= 60 seconds
Downlink Command: 0x01
Format: Command Code (0x01) followed by 3 bytes time value.
If the
downlink payload=0100003C, it means set the END Node’s Transmit Interval to
0x00003C=60(S), while type code is 01.
➢
Example 1: Downlink Payload: 0100001E // Set Transmit Interval (TDC) = 30 seconds
➢
Example 2: Downlink Payload: 0100003C // Set Transmit Interval (TDC) = 60 seconds