ASSEMBLY
4 I
Screw-in the 6 cylinder head screws into the outer
holes of the braces from below and fasten the metal
support parts in this way. Do not over-tighten the
screws, hand-tight is quite sufficient.
NOTICE
While tightening the screws, pay attention to
the table top. The table top shall under no circumstances
be deformed or lifted in the center.
The table is now ready assembled.
Now the inner table top can be rotated by 360°.
CARE
The table is maintenance-free. For the care of the different stone types please see the
according material information.
INSTRUCTIONS FOR MOVING THE TABLE
For moving the completely assembled table, never carry it on the projecting edge of the
table top. The stone tops may break. Please use wooden bars, which must be set under the
support arms of the table top. But it is recommendable to disassemble the table.
REMOVAL
For a removal of the table, the table tops must be disassembled and transported well protected
and packed. The table tops must be transported separately and in the upright position.
A horizontal transport inevitably leads to a breakage of the table tops!
OPERATION
