CONTACT US AT
www.DRpower.com
31
Troubleshooting Table (Cont.)
S
YMPTOM
P
OSSIBLE
C
AUSE
;
S
OLUTION
Machine tracks left or right
when traveling at full speed
with both Levers against
the Handlebar Grips.
Control Levers may need to be adjusted; See “Adjustment the forward speed limit” on page 25.
Check the Wheel Tire pressures against the manufacturer’s recommendation listed on the side
of the Tires.
Machine turns fully left or
right when engaging both
Levers the same.
Check that both Neutral Bypass Links are pushed into the engaged/drive position
Check that axle/wheel key is installed locking both wheels to the axle.
A Belt frays or rolls over the
Pulley.
A Pulley groove may be rusty or have a nick in it. Clean the pulley with steel wool or file off any
nicks.
Check the Belt for wear and hard spots.
The Belt may be stretched, replace it.
Excessive vibration when
engaging the Blade.
Check the Blade for nicks and wear. Replace or sharpen and balance the Blade if they become
dull, or have them professionally sharpened if needed. Never try to straighten a bent Blade. Be
sure to replace the Blade in the proper orientation. See page 23.
May have debris wrapped around Blade (wire, etc.), Remove debris from Blade.
The Blade may not be seated properly on the Hub. Loosen the Blade Nut, reseat the Blade, and
tighten the Nut. Be sure to turn OFF the Engine and remove the Spark Plug wire(s) before
performing this operation.
Check and retighten all of the fasteners as required.
The Blade is not cutting or
is loose.
The Blade may not be seated properly on the Hub. Loosen the Blade Nut, reseat the Blade, and
tighten the Nut. Be sure to turn OFF the Engine and remove the Spark Plug wire(s) before
performing this operation.
Sharpen the Blade; it may be dull or nicked. Be sure to replace the Blade in the proper
orientation. See page 23.
The Blade will not Engage
and/or Disengage.
Be sure you are holding down on the Operator Presence Lever.
Be sure that the Cable is connected at both ends and not damaged.
Engagement Arm on clutch is stuck; Ensure that the clutch arm is returning to its resting
position.
Do not continue to use the machine if the blade will not disengage; visit our web site at
www.DRpower.com for assistance.
Blade is not cutting or
squealing noise is heard
when cutting.
Check the Belt for wear or stretching; Replace Belt as needed (see page 21).
Check the Blade Engage Cable for proper adjustment; Adjust Cable (see page 28).
Summary of Contents for XD26
