CONTACT US AT
www.DRpower.com
15
1
2
4
3
Figure 7
5
1
2
4
3
Figure 6
Wheels Hardware Set (
Figure 6
):
Item # Part #
Description
Qty
1 ............. A0001216052 ..... Washer, 1.00"ID X 1.58"OD X .134" Thick ....... 4
2 ............. 123341 ............... Bolt, HCS, 3/8-16 X 1.75", GR5, ZP .................. 4*
3 ............. 333331 ............... Nut, Nylon Lock, Flange, 3/8-16 ....................... 4*
4 ............. 126851 ............... Pin, Cotter, 3/16" X 1.5" .................................... 2
* This hardware will not be used (with or on) your PRO MAX450 machine.
Power Unit Hardware Set (
Figure 7
):
Item # Part #
Description
Qty
1 ............. 265561 ............ Bolt, HCS, 1/2-13 X 2.75", GR5, ZP ............... 2
2 ............. 350231 ............ Bolt, Hex, Flange, 5/16-18 X .75" ................... 4
3 ............. 112431 ............ Washer, Lock, 5/16", Split, ZP ....................... 4
4 ............. 112411 ............ Washer, Flat, 5/16" USS, ZP .......................... 4
5 ............. 333351 ............ Nut, Nylon Lock, Flange, 1/2-13 .................... 2
Installing the Wheels
(Use Wheels Hardware Set, see Figure 6)
Tools Needed:
•
Pliers
1.
Position the Rear Frame/Collector Base Assembly upside down (
Figure 8
).
2.
Install the Axle into the Axle Actuator Mount.
3.
Slide a Wheel onto each end of the Axle with the Valve Stems facing in
(
Figure 9
).
4.
Slide a Washer onto the Axle against each Wheel.
5.
Slide a second Wheel onto each end of the Axles with the Valve Stem facing
out (
Figure 10
).
6.
Install a 1.00" ID X 1.58" OD X .134" Washer against each Wheel and insert
Cotter Pins into the Axle holes. Use Pliers to bend the ends of the Cotter
Pins to secure the Wheels.
Figure 10
Washer
Wheel
Air Valve
Cotter Pin
Figure 9
Washer
Wheel
Air Valve
Frame
Assembly
Figure 8
Axle
