16
DR
®
PILOT 4 Cycle Tiller/Cultivator
Figure 14
3.
Remove the foam filter and fiber filter elements.
Replace with a new fiber filter and a new oiled foam
filter (
Figure 13
), or clean the original foam and fiber
filters with warm water and mild soap.
4.
Remember to thoroughly oil the foam filter with 30 or
40 weight motor oil and squeeze out any excess oil
before reinstalling it. Make sure to press the foam filter
evenly into place over the fiber filter to ensure that the
foam is fully seated into its sealed position.
5.
Replace the air filter cover by first connecting the back
latch tabs then swinging the cover, making sure the
foam filter block stays fully seated and in its proper
position, and connect the front latch tab so that it is
secured into place.
6.
Screw the cover bolt back into place. Check that the
cover is securely attached by pulling slightly on the
cover. If the cover doesn’t move when pulled, it is
secure.
Tine Removal and Installation
TO REMOVE TINES
1.
Remove the hairpins from each end of the tine shaft
(
Figure 14
).
2.
Slide the four tines off the shaft.
TO INSTALL TINES
1.
First slide the inside tines onto each end of the tine
shaft (
Figure 14
). One inside tine is stamped with a B
and the other is stamped with a C.
2.
Slide the outside tine A and tine D onto each end of
the shaft next. The tines should be installed in the
correct order so that they are positioned left to right A,
B, C, D, as viewed from the user’s position on the
Tiller/Cultivator. Make sure that the hub collars on
both the right and left pairs of tines face each other so
that there is adequate spacing between the tine blades.
3.
Insert the hairpins into the holes at each end of the
tine shaft to lock the tines into place.
Note:
Tines can be reversed so the pointed tip of the tines
are directed forward - for more aggressive digging. In this
arrangement, tines are positioned left to right D, C, B, A as
viewed from the user’s position
Never twist air filters when cleaning. Always press.
Figure 13
Summary of Contents for PILOT 4
