1
2
3
4
5
6
7
8
1.
Input:
Input jack for your guitar.
2. Volume:
Controls the volume of the input signal. Set low for clean, high for distor�on.
3. Treble:
Controls overall high frequency response.
4. Middle:
Controls overall mid frequency response.
5. Bass:
Controls overall low frequency response.
6. Master:
Controls the amount of signal reaching the output sec�on.
7. Level:
Controls the overall volume of the amp.
8. Stand-By:
Leave in off posi�on for 1 minute when powering up the amp. Turn on for play. Place in off posi�on for
extended break periods.
9. Power:
Switch up to turn on amplifier. Switch down to turn off amplifier.
10. Power Indicator:
Lights up when power is switched on. If bulb fails replace with type T47.
FRONT PANEL
REAR PANEL
11. AC Inlet:
(Class I Wiring). This device is used for disconnec�on from power mains and must remain readily
opearable. The power indicator light does not indicate connec�on to power mains. The power cord must be
disconnected to disconnect amplifier from power mains.
12. Fuse:
The fuse protects the amp from electrical faults. Replace only with the same ra�ng and type stated
below fuse holder (1.5A 250v SLO BLO). If the amp repeatedly blows the fuse contact your dealer or Dr Z Amps.
13. External Speaker Jack:
Plug in an 8 Ohm external speaker here. Wired in parallel for a 4 Ohm total load.
14. Internal Speaker Jack:
Plug in supplied 8 Ohm Z12 speaker in here. Always have a speaker plugged into the
amp when it is powered on. Always match a 8 Ohm speaker with this output jack. This will allow the amp to
sound its best and avoid damage.
15. Return Jack:
Plug the “out” of your effects chain to return the signal back to the amp.
16. Send Jack:
This will send the signal from the amp to the “in” of your effects chain.
17. EQ Bypass Footswitch Jack:
Plug supplied single bu�on footswitch in here. This will enable you to engage
the EQ bypass/gain boost mode. The variable boost footswitch features an knob to control the amount of boost.
Simply turn this knob clockwise to increase the amount of boost.
9
10
11
12
SPEAKER OUTPUT
CLA S S 2 WIRING
RISK OF ELECTRICAL SHOCK
DO NOT OPEN
RISQUE DECHOC ELECTRIQUE
NE PAS OUVRIR
C AUTION AVIS
FUSE
1.5A 250V
INPUT POWER
120V
~
60Hz 120 W
- AMP
®
RETURN
EXTERNAL
INTERNAL
SEND
EQ
BY-PASS
FOOT SWITCH
DATE OF MFG:
MODEL # ZA-41
SERIAL N O.
13
14
15
16
17
