10
6.0
Safety instructions
Important
Only use the core drill under supervision. Disconnect the mains plug and check
that the switch has been turned off,
-
if you intend to leave the core drill unsupervised,
-
for attachment and disconnection work,
-
if the voltage drops (below 200 V),
-
for adjustments or for fitting an accessory,
Switch off the machine if it stops for any reason. This will prevent its starting suddenly when it is not under
supervision.
Do not use the tool if
-
part of the casing is missing or defective,
-
If water drips out of the overflow hole, stop work and have the core drill inspected by an authorised
service contractor.
-
Only drill above your head with suitable safety equipment (water collector), RCD and transformer
protection class II.
-
Connect dust extraction if required.
-
After a fault do not switch on the machine again until the core bit can be turned easily.
-
Check the area you wish to drill with a line detector to prevent drilling through electric cables, water
or gas lines, etc.
-
the switch, lead or plug connector has suffered damage (conduct a visual inspection every day).
-
Cooling water must not be allowed to ingress into the motor or the electrical components when op-
erating the core drill in any position.
Do not expose the tool to rain and use not in humidity or wet environment. Use a good lightning. Do not use
the tool near flammable fluids or gase air mixes.
