Troubleshooting
Failure
Possible cause
Processing method
Can not work after
supplied power
Didn’t turn on the power switch
Didn’t choose massage program
Bad connection between plug and socket
Power cord or plug damaged
The fuse burned up
A fault in the controlling circuit
Turn on the switch
Choose a massage program
Connect again
Replace the power cord
Replace the fuse
Contact with the maintenance
department of supplier
Working with tap-tap
-tap or hum sounds
Different hight for
the massage rollers
Abnormal sounds
suddenly occurred
while working
Suddenly stopped
working
Can not recline
Can not restore after
relined
Control panel
overheat seriously
Abnormal overheat
from
power wire and plug
Sounds from air pump, motor or other
mechanical parts
Rollers under alternately work
If after long time works
Cause from long time work
If after long time works
Auto programmed time is up
Obstructer there; work overloaded
automatically
stopped work for protecting machine
Problem on electromotion pole or plug-ing
under bad connection
Cause from long time work
Work overloadingly
Causes from other resons
Normal phenomenon
Normal phenomenon
Cut down the power and check after
30 minutes
Contact with the maintenance worker
Supply power again
Cut down the power and use after
30 minutes
To move the obstructer; stop work and
use after 30 minutes
Contact with the maintenance worker
Cut down the power and call the
maintenance worker
Cut down the power and use after 30
minutes
Cut down the power and call the
maintenance worker
Attention
If problems all are not from above reasons, please stop power supply and contact
with the distributor or factory for maintenance.
Relaxology Massage Chair
