13
7. Type "quit" to exit FTP.
If the configuration file is not correctly formatted, you will see a STOR error message, which will state that the data could
not be stored. If you see a STOR error, verify the formatting of the configuration file and upload again. (For information on
configuration file formatting, see Section 6.4, "Configuration File."
After uploading, the DAC-P must be rebooted for the new configuration to take effect.
There are four ways you can reboot the DAC-P:
1. Type "REBOOT" at the FTP password prompt.
2. In the DAC-P terminal interface, choose C)onfig > E)dit > s(Y)stem > R)eboot. (See Section 6.6.1).
3. Cycle power to the DAC-P unit.
4. Select the Reboot command from the LCD display menu. (See Section 9).
Other Configuration Options
6.6
More configuration options are available through the DAC-P's terminal interface. To select these options, start a terminal
session with the DAC-P, either locally through the craft port or remotely via Telnet.
6.6.1 System
Fig. 15. System menu commands
To edit identification information for the DAC-P, choose C)onfig > E)dit > s(Y)stem.
The System menu contains commands for editing the name of the DAC-P unit, its location, and the primary contact person
responsible for the unit.
The C)onfig > E)dit > s(Y)stem > R)eboot command reboots the DAC-P. If you choose the R)eboot command, a
confirmation prompt will ask you to confirm your choice.
Summary of Contents for DAC-P
Page 42: ......