ORACLE V1.4 ©2007-2008 DIGITAL PRODUCTS COMPANY
P
AGE
5
Jan-2008
S
TART OF
P
ROGRAMMING
Programming begins by holding down the pushbutton switch while you apply power.
Continue to press the switch until the yellow S
TATUS
LED is on. The audio buzzer will
also begin to sound off. When you are ready start programming, release the switch. Now
the fun begins!
Step 1:
Video Type.
Range: 1= NTSC, 2= PAL
This entry is used to set the video mode of your two wireless video receivers. For
example, press once for NTSC video.
Step 2:
Switching Alert Chirp
Range: 1= On, 2= Off.
This entry is used to control the audio alert that is heard whenever the video
sources are automatically switched. For example, press twice to disable the chirp
noise.
Step 3:
Low Battery Alert Beep
Range: 1= On, 2= Off.
This entry is used to control the low battery alarm beep. For example, press once
to enable the voltage alarm beep.
Step 4:
,,
Low Battery Voltage (N)
Range: 6 to 13 VDC (in 1 volt increments).
This entry configures the low voltage alarm threshold. To set the alarm to 6.5V, press six
times. Note: the following step will be used to enter the remaining 0.5V value.
Step 5:
,,
Low Battery Voltage (.n)
Range: 0 to 0.9 VDC (in 0.1 volt increments).
This entry is a companion to Step-4 and is used to enter the one-tenth volt value.
For example, if the desired threshold is 6.5V, press six times at Step-4 and five
times at this step. To enter a “.0" value (i.e., 6.0), do not enter any key presses
(wait a few seconds for the step to end).
