AV681TX-Kit, Rev B
Page 6
© Nov-03-2008
Figure 9, Foam Pad
Figure 10, Heatshrink
10
FINAL ASSEMBLY: JOIN THE TWO PCB’s TOGETHER
9
10.1 Using an approved PCB cleaner, remove the flux
from ALL soldered connections. Flush trim all the
component leads from sides
â
and
å
.
9
10.2 Inspect your work. Now is the time to find errors --
once the boards are joined it will be very
inconvenient to do this.
9
10.3 See Figure 9. Cut the double-sided foam pad in
half. Stack the two pieces together to form a thicker
pad. Install the pad on the RF end of the Airwave
module.
9
10.4 Stack the two PCB’s with sides
ã
and
ä
facing each other. The four posts will
mate with the corresponding holes on side
ã
.
9
10.5 While lightly squeezing the foam pad end, ensure that the
two boards are parallel and close together. There should
be a slight air space between the Vreg ICs’ surfaces and
the top of the Airwave module. Hold this position while
you solder the four posts. Trim the excess leads.
9
10.6 See Figure 10. Slide a 1.75 inches (45mm) long piece of
heatshrink over the transmitter so that it covers the end
with the exposed electronics. About 0.25 inches (6mm)
should hang over the end that has all the wires. Airflow is
needed so do NOT totally cover the end. Use a heat gun
or hot hair dryer and neatly shrink the tubing. Matches
and lighters are not recommended.
11
FREQUENCY CONFIGURATION
11.1 The DIP switch is used to change the transmitted frequency. The transmitter and
receiver must both be on the same channel. The three switches are set as
follows:
CH
MHz
SW1
SW2
SW3
OFF = switch open
(Front position)
ON = switch closed
(Back position)
1
5740
ON
ON
ON
2
5760
ON
ON
OFF
3
5780
ON
OFF
ON
4
5800
ON
OFF
OFF
5
5820
OFF
ON
ON
6
5840
OFF
ON
OFF
7
5860
OFF
OFF
ON
