AV680RX-Kit, Rev-B
Page 5
© Nov-03-2008
Figure 8, Coax Installation
Figure 9, Covers Installed
9
5.4
Do not use the SMA-RP connector
when installing dpcav.com’s
#AWM5.8ANT economy patch
antenna (available separately).
Instead, directly solder the coax to
the RF port. See Figure 8.
Warning: While soldering, do not
disturb the tiny SMD component
installed on the input pad of some
RF modules.
Ensure the coax braid is not shorted
to the center coax conductor on the module’s RF input. Perform a visual
inspection (do NOT use an ohmmeter).
6
COVER INSTALLATION: See Figure 9.
9
6.1
Using the 2-56 screws, install the four female-female standoffs to the top cover.
9
6.2
Place the top cover over the main PCB and attach using the four male-female
standoffs. The LED should protrude through the hole in the top cover. If the LED
has not been soldered, then now is the time to do that.
9
6.3
Attach the bottom cover using the 2-56 screws.
9
6.4
Apply the four rubber feet to the bottom cover.
