AJAH.418266.007RE
19
Appendix D
(Obligatory)
SOFTWARE “TETRA_Checker”
USER MANUAL
Co nt ent
D.1 Purpose of the software …………………………….…….……... 19
D.2 Description of the interface …………………...………….……... 19
D.2.1 Overview of the main window ………………...…………. 19
D.2.1.1 “Parameters” button …………………………….……… 20
D.2.1.2 Information panel……………………………….…….… 21
D.2.1.3 “Measuring data” panel ………………………..……….
21
D.2.1.4 “Device status” panel …………………..………………. 21
D.2.1.5 “Device parameters” panel …………..…………………. 22
D.1 PURPOSE OF THE SOFTWARE
The “TETRA_Checker” software (hereinafter – “program”) is intended for adjusting and
calibration of devices and detectors (hereinafter – “device”).
The program allows doing the following:
-
read and indicate values of the device parameters;
-
write the net address into the device;
-
write values of the dynamic parameters into the device; nomenclature of parameters is
defined by the device itself;
-
select one of the measured quantities in the device as a quantity requested by default;
-
indicate information about the operation of the device and measurement results on the
monitor of personal computer;
-
indicate the device status information on the monitor of personal computer.
ATTENTION!
BUGS
ARE
POSSIBLE
WHEN
USING
THE
PROGRAM
SIMULTANEOUSLY WITH NET CLIENTS (ICQ clients, Skype, GTalk, Jabber etc.). IF THIS IS
THE CASE IT IS RECOMMENDED TO CLOSE ALL ABOVE MENTIONED CLIENTS
(SOFTWARE) AND RESTART THE PROGRAM.
D.2 DESCRIPTION OF THE INTERFACE
D.2.1 Overview of the main window
The overview of the program’s main window is shown on the figure D.2.1. In the main window
the following interface elements are located:
-
“Parameters” button;
-
Information panel;
-
“Measuring data” panel;
-
“Device status” panel;
-
“Device parameters” panel.
