Dovre 94992, Instruction Manual

Page: 18 / 26

18
Assembly
It is best for assembly to be performed by
two people.
Follow the instructions carefully and look at
the pictures at the back of this instruction
manual.
Figures 1-2 - bag 1
Place a washer, a wheel (9), a washer and a
split pin on each axle. Bend the legs of the
split pin away from each other so that the
wheel locks securely to the axle.
Figures 3-4-5 - bag 2
Put the support leg (12) and frame (6)
together so that the screw holes line up
with each other. The handle (10) must be
fi tted at the opposite end to the assembly
position of the motor housing. Fasten the
parts together with 3 sets of bolts, washers
and lock nuts.
Put the frame and axle section (8) together
so that the screw holes line up with each
other. Fasten the parts together with 3
sets of bolts, washers and lock nuts. Wait
to tighten them fully until all the bolts are
inserted into the holes.
Figures 6-7-8 - bag 3
Lower the cradle (5) with the lower drum
section into each end of the frame. The
cradle’s toothed wheel should be at the
same end as the wheels on the frame.
Secure the cradle using bolts, washers and
lock nuts.
Figures 9-10 - bag 5
Place the rubber gasket (2) around the inner
edge of the lower drum section (5). Lower
the upper drum section carefully onto the
lower drum section so that the holes are
lined up. Screw the two drum sections
together.
Figure 11 - bag 6
Screw the mixer arms (11) securely to the
two drum sections using bolts, washers and
lock nuts.
Figures 12-13-14-15 - bag 4
Secure the adjusting disc (7) by placing two
bolts through it and screwing them to the
threads on the cradle fi tting.
Screw the bolt into the thread on the
turning handle (3). Place the solid washer
and the spring into the tube on the turning
handle and push the turning handle over
the cradle’s axle at the end where the
support wheel is located. Screw the turning
handle securely to the axle using a bolt, a
washer and a lock nut. Tighten the bolt so
that the spring is pressed towards the axle.
Figure 16 - bag 7
Position the motor housing over the axle
and line it up so that the holes in the frame
line up with the holes in the motor housing.
Secure the motor housing using bolts and
washers. Wait to tighten them fully until all
the screws are inserted into the holes.
Lubricate the gear rim on the drum using a
grease gun before use.