Hand Sanitizer
Original Instructions
2
8
Microcontroller
Technical specification
Supply voltage
220 (V) 50 (Hz)
Electrical connection
With grounding
Standby power consumption
4 (W)
Maximum electrical power consumed during operation
30 (W)
Weight when unfilled
22 (kg)
Length x width x height
286 x 286 x 1180(mm)
Disinfectant tank capacity
5 (l)
Equipment body material
MDF
The wiring diagram of the sanitizer is available
here
.
3.2.
Use of hand sanitizer
The hand sanitizer is intended for indoor use, where it is protected from atmospheric
precipitation or chemically aggressive environments. Before using the hand sanitizer, place it on
a horizontal and level floor. Unlock and open the door on the side of the station. Unscrew the cap
of the sanitizer tank and pour in the disinfectant fluid. The longest service life of the disinfection
station will be if the disinfection solution contains ethanol, glycerin, 1-propanol. Solutions
containing isopropanol are less recommended.
Do not use gel disinfectants to fill the hand sanitizer station! They can cause
permanent damage to the sanitizer.
Connect the station to the 220 (V) 50 (Hz) mains and switch on the power switch 14
located on the outside (see section
). After switch-on pump will work for 3 seconds to fill in
the system. Place your palms under the console attached to the top of the station. An infrared
sensor will be activated to start the electromagnetic pump, and when the system is filled with
Døvigen AS | Grenseveien 99 | 0663 OSLO | Telefon 23 05 10 50 | www.dovigen.no | [email protected]
