DoubleSight PC EXPANION, User Manual

Page: 31 / 68

2-14
Software Installation and Operation
If you finished the setting, click Save. Click Connect (or Try Again.)
Your PC EXPANION terminal should be connected to the host PC. You are now ready to use your PC EXPANION terminal.
Type ipconfig in the DOS command line and press Enter. IP address, Subnet mask, and Gateway that was allocated on the Host PC will be displayed on
the screen.
Connecting by Using a Switch (Supports 100 Mbit/sec Switching)
To connect by using a switch, you have to set a static IP address on both the PC EXPANION terminal and the host PC. To configure an IP address
as static, follow these steps:
Click Start and click Control Panel. (In Windows 2000, click Start, point to Settings, and then click Control Panel.)
Click Network and Internet Connections, and then click Network Connections. (In Windows 2000, double click 'Network and Dial-up
Connections.')
Input the displayed IP address into Terminal Server network address.