rev:12.07.17
2.
ASSEMBLY
2.1.
Required exploitation conditions
The unit and ducts should be assembled in rooms with temperature 5
°
C
- 30
C
and heat-separated
form surroundings.
Not following above conditions will cause liquefaction of condensate and cumulate it inside and outside
of the unit which may cause dampness in the room or damage to the unit.
2.2.
Pre-assembly requirements
While planning the assembly of the unit consider:
-
ensuring the expliotation conditions of the unit
-
possibility of bringing about ventilation pipes to the device
-
possibility of siphonning of steam condensate
-
possility of bringing about electric energy
-
easy access to maintenance and repairs
2
WARNING!
1. Ventilation installation and other belonging elements must be in accordance with Polish Norms
referring to ventilation in residential and public utility buildings.
2. The unit is not destined for drying the unseasoned houses.
3. In case of damage to elements arising from not following the above instructions,
they will be not repaired under warranty.
4. Due to design reasons there is a possibility of mixing the air inside the unit with amount
not exceeding 2%.
Prior to connecting the unit check elements condition, including casing and wiring. In order to avoid any damage,
the unit should be kept in safe place in original packaging.
2.3.
Unit location
The unit is destined for assembly under dry roofed rooms with basements (attics, utility room).
The unit should be assembled in a way to allow free drain condensate from the tub.
WARNING!
Manufacturer does not include assembly elements with the unit. Buyer should purchase elements separately.
After unit is placed, it shoud be leveled. It has an essential meaning for proper work of the condensate
drainage system.
Optimal 400/600
EN
