Operation
15
6.
On these larger stumps, DO NOT allow grinder wheels to drop into stump hole. If a hole is in
the way of your progress, fill it with chips or change position.
WARNING
:
Stop engine and set brake before leaving operator's position. KEEP BRAKE
ENGAGED except when changing locations.
7.
When finished, stop the machine.
8.
Pull machine away from stump, and rake chips away from stump.
5. Refueling
1) Before removing gas cap, turn engine off and allow to cool for at least two minutes.
Note:
A running or hot engine can ignite fuel.
2) Remove grinder gasoline cap.
3) Add gasoline through the fill opening:
-
Use only an UL-approved portable gasoline container to transfer the gasoline to the grinder's
tank.
-
Be aware of safety warning and instructions below for avoiding static electric caused fires.
-
Do not overfill.
WARNING:
Static electric spark hazard
A static electric spark can explosively ignite gasoline vapor,
resulting in a flash fire that could cause serious injury or
death. See "Special Safety Information on Static Electricity" at
end of this manual.
4) Clean up gasoline spills /splashes immediately.
If possible, move the grinder
away from spilled gasoline
on the ground.
Wipe up spilled gasoline, and wait 5 minutes for excess
Wheel
Chip pile/debris
Hole
NOT CORRECT
CORRECT
