English
Use of answer machine (base unit)
The number in the base units’ display will flash when
there are new messages.
and the numbers on the base unit will flash when
there are new messages.
Press
9
(base unit) to start playback.
Command
Function
8 8
/
9 9
..........Prev msg/Skip forward.
■
......................Stop playback.
X
......................Delete current message.
VOL + / -
..........To increase/decrease the volume.
Delete all old messages
After playback: Hold down
X
until you hear a beep.
Use of answer machine (handset)
New messages are indicated by
flashing in the display
in standby mode. Playback always starts with new messages.
1.
Press . Scroll to
ANS. MACHINE
. Press
OK
.
2.
Scroll to
MSG PLAYBACK
. Press
OK
.
3.
During playback the following commands are available.
4.
End by pressing
L
.
Command
Function
2 (
X
).................Delete during playback
4 (
8 8
) .............Previous message
5 (
■
) .................Stop
6 (
9 9
) .............Skip to next message.
......................Speaker Off/On. Only NeoBio 25r.
}
/
{
................Volume control
Delete all old messages
1.
Press . Scroll to
ANS. MACHINE
. Press
OK
.
2.
Scroll to
DELETE ALL
. Press
OK
.
3.
Confirm by pressing
OK
.
Answer machine settings
1.
Press . Scroll to
ANS. MACHINE
. Press
OK
.
2.
Scroll to
TAM SETTINGS
. Press
OK
.
3.
Scroll to desired function. Press
OK
.
4.
Scroll to desired setting. Press
OK
.
ANSWER MODE
Choose between
ANSWER & REC
and
ANSWER ONLY
(caller cannot
leave message).
TAM LANGUAGE
Select language for pre-recorded
outgoing message. To activate this,
press
C
during playback of outgoing
message.
OGM SETTINGS
Record/listen to outgoing msg.
ANSWER DELAY
Select after how many rings (2,4,6,8,
time saver*) the call will be answered.
RECORD TIME
Select maximum recording time for
each msg.
REMOTE ACC.
Select remote access off/on.
COMPRESSION
Higher compression gives longer
recording time but reduced sound
quality, LOW = best sound quality but
about half memory capacity.
BS SCREENING
This function in base unit is described
elsewhere.
CHANGE PIN
Change remote access code (0000).
The Time Saver function answers calls after six ring signals,
until the first new message has been registered - then the
answer machine switches to answering after approximately two
signals. This is useful when using remote access; if you call up
the answer machine and there is no reply after four rings that
means there are no messages recorded and you can hang up
before you are charged for the call.
Personal message (Memo)
1.
Press . Scroll to
ANS. MACHINE
. Press
OK
.
2.
Scroll to
MEMO
. Press
OK
.
3.
After the long beep you can record your message
(speaking approx. 20 cm from the keypad).
4.
Press
OK
. The message will be played back to you.
5.
Memos are played back in the same way as ordinary
incoming messages.
